News
新闻资讯
- 我国精密模具市场前景可期!
- 如何谨慎的修理模具,主要的修复方法有哪些?
- 精密注塑制品出现披锋该如何调整?
- 当下中国模具行业市场现状及发展方向,值得借鉴
- 2021年中国汽车注塑模具市场现状及发展趋势预测分析
联系我们
手机:18020299888
电话:0510-85436666
邮箱:651706814@qq.com
地址:No. 29-2, Lu Ou Road, Hudai Industrial Park, Binhu District, Wuxi City
Company news
Why should the exhaust system be set for injection mold?
- 作者:管理员
- 发布时间:2022-08-05
- 点击:31
The exhaust of injection mold is an important problem in mold design, especially in rapid injection molding, the exhaust requirements of injection mold are more strict.
(1) The source of gas in the injection mold.
1) Air in the gating system and mold cavity.
2) Some raw materials contain water that has not been removed by drying, and they are vaporized into steam at high temperature.
3) The gas produced by the decomposition of some unstable plastics due to the high temperature during injection molding.
4) Gases generated by volatilization or mutual chemical reaction of some additives in plastic raw materials.
(2) Hazards of poor exhaust
Poor exhaust of injection mold will bring a series of hazards to the quality of plastic parts and many other aspects. The main performances are as follows:
1) In the process of injection molding, the melt will replace the gas in the cavity. If the gas is not discharged in time, it will make it difficult to fill the melt, resulting in insufficient injection volume and unable to fill the cavity.
2) The unsmooth gas will form high pressure in the mold cavity and penetrate into the plastic interior under a certain degree of compression, resulting in quality defects such as pores, cavities, loose tissue, crazing and so on.
3) Because the gas is highly compressed, the temperature in the mold cavity rises sharply, which leads to the decomposition and burning of the surrounding melt, causing local carbonization and charring of the plastic parts. It mainly appears at the confluence of two melts, the * angle and the gate flange.
4) The poor elimination of gas makes the melt speed entering each cavity different, so it is easy to form flow marks and fusion marks, and reduce the mechanical properties of plastic parts.
5) Due to the obstruction of gas in the cavity, the mold filling speed will be reduced, the molding cycle will be affected, and the production efficiency will be reduced.
(3) Distribution of bubbles in plastic parts
The sources of gas in the cavity are mainly divided into three categories: the air accumulated in the cavity; Gas generated by decomposition in raw materials; The positions of bubbles produced by the evaporation of residual water in raw materials are different due to different sources.
1) The bubbles generated by the accumulated air in the mold cavity are often distributed on the position opposite to the gate.
2) Bubbles generated by decomposition or chemical reaction in plastic raw materials are distributed along the thickness of plastic parts.